To install t-top shade extension you need to follow these steps:
- Clean the area around your t-top, and remove any loose objects. Make sure to clean up any shavings; you should avoid blowing them into the boat.
- Unscrew the T top gasket cover screws on both sides of the opening for the extension rail from their respective fixtures in order to allow an easy installation process due to a lack of interference with other components around it such as seats or sunroofs.
- Then screw in place one end plate onto each side. The rubber seal goes against half of this piece, while sliding -into- its slot inside the rail at each end before tightening down screws just enough so that they remain snug without binding. This ensures that t-top shade extension will not brake down during bad weather conditions.
- Screw in the other end plate at the opposite side, then tighten screws by hand while holding rail tight against T top gasket seal edges with screwdriver handle for a more accurate measure of pressure before complete installation.
- Install and release t-top shade extension from its locked position when ready for use as desired.
Thesandshore.com is a source where the post How to Install Boat T-top Shade Extension appeared first.